More Blogs

Tips, inspiration and expert advice

Can you paint aluminum siding? A complete guide

Blog · November 18, 2026 · By PaintPro Tennessee

Learn whether aluminum siding can be painted, how to check it with the chalk test, and how to clean, prime and paint it for a lasting finish. The guide also covers weather limits and typical costs.

Yes, you can paint aluminum siding if the panels are sound. Check for chalk, peeling, dents and rust before you buy any paint, because those problems decide whether a fresh coat will hold.

Can aluminum siding be painted?

Most aluminum siding can be repainted. The factory coating does not have to be stripped off, but any extra coats of paint that are peeling need to be scraped and sanded away. Family Handyman notes that aluminum siding is usually painted every 10 years or so to keep it looking good.

Start with a chalk test. Rub your hand across the siding. If a powdery residue comes off on your palm, the paint has oxidized and the surface is ready for a new coat. Diamond Vogel explains that the coating can erode, chalk and fade over time, and in severe cases the bare metal can oxidize.

Next, look for dents, dings and corrosion. Repair any damaged spots first. If a piece cannot be repaired, replace that panel before painting. Family Handyman advises fixing or replacing damaged siding before you paint, since paint will not hide a dent or a rusted hole.

If the siding is cracked, badly rusted or peeling down to bare metal across large areas, repair or replacement often comes before paint. Sound panels with only chalk and light fading are good candidates for a repaint.

How do you clean and prep aluminum siding for paint?

Remove all the chalk, mildew and loose paint before you open a can. Paint will not bond to a chalky or dirty surface, so skipping this step is the most common reason a repaint peels early. For more on planning a repaint, see PaintPro's painting tips and color advice.

For a light coat of chalk, Diamond Vogel recommends washing with warm, soapy water or a pressure washer rated at 2,500 psi minimum, then checking again with the hand test. This Old House suggests scrubbing with a mix of one cup bleach and one cup TSP in one gallon of water to lift dirt, mildew and chalky residue, then wiping the siding dry.

Loose or flaking paint should come off before priming. This Old House recommends removing it with a random-orbit sander and 100-grit disk, with the sander connected to a wet/dry vacuum fitted with a HEPA filter. Work from the top of each wall downward, and keep water from running under the panels.

Rinse thoroughly after any cleaner, and let the siding dry completely. Paint applied over a damp surface will not cure properly. Once the siding is clean and dry, you are ready to prime.

Which primer and paint should you use on aluminum siding?

Use a 100% acrylic latex primer, then two coats of 100% acrylic latex exterior paint. This Old House recommends this sequence: one coat of 100% acrylic-latex primer, followed by two coats of 100% acrylic-latex paint. Avoid oil-based products, since This Old House notes they do not perform as well on aluminum.

Choose a primer made for metal surfaces, and buy exterior paint with 100% acrylic content. Glidden states that 100% acrylic formulas protect against UV rays, color fading and weather.

For finish, a satin or flat sheen works well on siding. Diamond Vogel notes that a flat finish helps reduce the look of surface imperfections such as dents. Glossier sheens show more of the dents and waviness in the panels.

Keep the color close to the current one. Family Handyman explains that a similar or lighter color is easier to achieve, while extreme color changes may need extra coats to reach the true shade.

When is the weather right to paint aluminum siding?

Paint when the air and surface temperatures are at least 35°F and no freezing is expected within 48 hours. Sherwin-Williams lists 35°F as the minimum for its A-100 exterior latex, and warns against applying when temperatures may drop below that within 48 hours. Large expanses of metal siding need air, surface and material temperatures of 50°F or higher, according to the same product sheet.

Avoid direct midday sun, especially in summer. Heat can dry paint too quickly, which can cause brush marks, lap marks and poor adhesion. Paint the shaded side of the house first, or start early in the morning.

Check the forecast for rain as well. Sherwin-Williams advises against painting if rain or snow is expected within two to three hours.

Moisture on the surface also matters. Paint manufacturers generally recommend keeping temperatures above the dew point for at least 48 hours after application so the paint film can form properly.

What does it cost to paint aluminum siding?

A typical Nashville house paint job runs about $4,301 to $5,657, based on more than 4,000 completed projects in the Nashville area. The full range across those projects is $3,623 to $6,335. Labor makes up 70 to 90% of the total, so most of the price is the crew's time, not the paint.

Prep and access also move the price. Heavy chalk, damaged panels and multiple stories all add time. Siding repairs before painting, such as replacing dented or rusted panels, are a separate cost on top of the paint.

Hiring out makes sense when the house is tall, the prep is heavy, or you want the job done in a set window. DIY can work on a single-story home with sound siding and good weather, where you can give the prep the time it needs.

For a quote tailored to your house, you can request an estimate from PaintPro Tennessee's contact page.

Related resources

Learn more about our exterior house painting services.

Planning a painting project in Middle Tennessee?